EGG 5208 device
Lock-In amplifier
Status:
Initial release version: 1.24.97.120, Torben Worm
The EGG 5208 device is part of the GPIBDevices project. See GPIBDevicesVersion for versioning. This documentation applies to version 1.24.97.120
Contents:
Overview:
The EGG 5208 GPIB device controls . Most relevant functions have been implemented.
Device parameters:
For addressDefinition the device uses AddTypeId number 10 (Two-dim address). a0=0: Device control. a0=1: Instrument control. a1: Parameter number.
Device/ |
Parameter number (a1) |
Suggested |
Parameter name |
Data Type |
Interpretation |
Comment |
0 | 0 | Enable | Enable the device | Bit | Check box | |
0 | 1 | Reset | Resets the device if enable | Bit | Push buttom | |
0 | 2 | ErrNo | Status of last instrument operation | Word | ||
0 | 3 | ErrStr | Status of last instrument operation as text | String | ||
0 | 4 | MeasMode | Measurement mode | Word |
Radio button Continuous/ Triggered |
|
0 | 5 | Trig | Update delay | Double | in seconds | |
0 | 6 | MeasDelay | Trig measurement | Bit | Push button | |
1 | 0 | Output mode | Word | |||
1 | 1 | Sensitivity | Word | |||
1 | 2 | Sensistivity autoscale | Bit | |||
1 | 3 | Phase mode autoscale | Word | |||
1 | 4 | Phase | Word | |||
1 | 5 | Channel 1 data | double | |||
1 | 6 | Channel 2 data | double | |||
1 | 7 | Aux data | double | |||
1 | 8 | Reference mode | Word | |||
1 | 9 | Reference frequncy | double | |||
1 | 10 | Display mode | Word | |||
1 | 11 | Dynamic reserve mode | Word | |||
1 | 12 | Db/Octav | Word | |||
1 | 13 | Time constant | Word | |||
1 | 14 | Output mode read back | Word | |||
1 | 15 | Sensitivity read back | Word | |||
1 | 16 | Frequency band read back | Word | |||
1 | 17 | Db/Octav read back | Word | |||
1 | 18 | Time constant read back | Word | |||
1 | 19 | Frequency band read back | Word | |||
1 | 20 | Reference mode read back | Word | |||
1 | 21 | Dynamic reserve read back | Word | |||
1 | 22 | Display mode read back | Word | |||
1 | 23 | Phase read back | double |
Device configuration:
The following parameters are setup by the ConsysManager and stored in the .config file at the front-end computer on which the device is loaded:
- GPIB address (default is 1)
- Base file name for persistant store of settings and histories
Description of setup:
This section is empty.
Last Modified 05 February 2020